Weltouch Cy-210b Manual -

Level One and Level Two wires connect to specific terminal screws (e.g., screw #6, #7, and #11) to initiate different weld schedules.

A: The CY-210B typically supports glove detection up to 3mm thickness. Test for optimal results.

: Avoid inserting metal objects like screws or coins into the controller housing, as this can cause permanent electrical failure.

| Parameter | Value | | :--- | :--- | | | 5V DC ±10% (USB) | | Current Consumption | Operating: 80mA / Idle: 30mA | | Interface | USB 2.0 Full Speed (12 Mbps) | | Report Rate | 80 - 120 Hz | | Touch points max | 10 (Windows 8/10/11) | | Operating Temp | -20°C to 70°C (-4°F to 158°F) | | Storage Temp | -30°C to 80°C (-22°F to 176°F) | | Dimensions (PCB) | 55mm x 35mm x 8mm |

Ensure the start signal is correctly applied; some modes prevent sequence execution if signals are fed improperly.

I should verify the technical specs. Is it compatible with certain microcontrollers? What are the operating voltage and current requirements? Include those details in the installation section. Also, mention any firmware versions if applicable.

Current can typically be set from 1.0 to 80.0 kA . Maintenance and Safety Precautions