Ts1162 Installation Manual Page

:

: If this keypad is the last device on the RS-485 LAN run, set DIP switch 8 to the "On" position to terminate the line. 4. Wiring and Termination ts1162 installation manual

Over-tightening panel screws can crack the TS1162’s front bezel, compromising its IP rating. : : If this keypad is the last

Check RJ45 connector on bottom.

: Power down the Challenger panel before beginning any wiring. ts1162 installation manual

Change the default printer name if using in a shared office.

Strip wires to approximately 7mm. Insert them into the terminal block and tighten the screws. Ensure there are no stray strands that could cause a short circuit.